- Wash the vehicle
- Take necessary parts off the vehicle
- Featheredge scratches with 220 -1/4" each layer as deep as the scratch is
- Final sand entire panel with 500 grit with interface pad
- Blow everything off with compressed air
- Wax and grease remove surface
- Clean jams and moldings 4 mask prep
- Tack rag everything
- If the area you fetheredge has a bare metal area smaller than a fifty cent piece use etching primer if larger use two coats of epoxy primer
- Two coats of primer surfacer
- Befor you sand let surface dry
- Put your guide coat on block with 320
- Sand guide coat and look for lows, use scuff pad to clean block sander
- If u think you are going to have to re-prime use 220
- Go over it with 500 DA after 320 if everything looks good
- Clean with soapy water clow it off with air blow yourself off so dirt doesnt come of you
- Wipe with wax and grease remover. put into booth and mask off
- Less folds in your paper better job
- Spray withprimer sealer if needed wait flash time usually 15 minutes one coat will be fine
- Tack befor pain
- Apply base coat. two coats is usually alright depends on the color let flash clearcoat
Thursday, October 20, 2011
class notes for painting a car
Ford Pickup Project
Tuesday, October 18, 2011
Thursday, October 13, 2011
Mid Week Auto Collision Repair Blast (3)...Training, News, Videos
Are you looking for auto body how to videos, collision repair news, and other automotive articles? Be sure to check out this week's Mid Week Auto Collision Repair News Blast!
This week you will learn about:
This week you will learn about:
- Weld On Panels
- Window Regulators
- Windshield Removal and Instalation
- Repairing Bird Dropings On Paint Finishes
- Collision Repair Scholarships
- Car Review
- New Bondo Detecting Tool
- and 100's of Auto Body How-to and News Videos
Subscribe to:
Posts (Atom)








